We rebuilt the International VT365 engine for our customer, all of our rebuilt engines are fully built top to bottom using brand new components and gaskets. The process of rebuilding the engine includes;
- Disassembly of the engine
- Manual scrubbing of heavy debris
- Engine degreasing
- Hot akaline spray jet cleaning
- Pnuematic wire brushing
- Ultrasonic cleaning
- Removal of broken studs
- Measuring all the various sizes of the components to manufacturer specifications
- Machining of cylinder bore to accept new pistons
- Check for warpage with straight edge
- Milling cylinder head surface
- Cutting valve seats
- Gnurling valve guides
- Machining valve surfaces or replacement
- Testing valve spring resistance
- Magnaflux cylinder heads for crack detection
- Adjust valve clearanceÂ
- Assemble cylinder head
- Machine crankshaft to accept new bearings
- Assemble engine with all new pistons, piston rings, rod bearings, main bearings, oil pump, timing kit, balance shaft bearings, valvetrain components, lifters, etc.
- Spin test engine
Must reattach all your original emissions system to maintain emissions compliance and cannot be installed into brand new equipment or downgrading from a higher emissions category.